A minute ago, the washing machine was working as usual, the laundry was “spinning in its dance” in the drum, and suddenly the noise was replaced by silence - the sensors went out, the washing machine stopped, and darkness reigned in the whole apartment. What happened?
- What to do if the washing machine knocks out traffic jams?
- The most common malfunctions of the washing machine, in which the RCD (or machine) is triggered
- Attention! Do not, under any circumstances, use a washing machine that knocks out corks.
- In the event that the washing machine causes broken plugs, immediately contact the repairmen for washing machines
What to do if the washing machine knocks out traffic jams?
You probably already understood yourself - traffic jams were knocked out in the apartment. And if you decide to resort to the help of the Internet, most likely you did not succeed in turning on the light yourself. Your suspicions for such tricks, of course, fell on the washing machine, as it consumes the most electricity.
But wait, do not make hasty conclusions, maybe it has nothing to do with it in the case when:
- your appliance is brand new, “fresh from the store”. In this situation, it is most likely that the wiring or incorrectly selected power protection devices may be the problem. For example, automatic machines or RCDs of insufficient energy intensity were installed.Make sure that the problem is centered on the wiring, perhaps by plugging a kettle or iron into this outlet, because they have similar power. When the plugs are knocked out again, it means it's time to worry and call an electrician!
- it is possible that other electrical appliances with a high energy consumption were switched on during washing. Imagine a typical day off for a Russian woman: the laundry is loaded, a festive dinner is being prepared on the gas stove, and a cake is blushing in the oven, and the hostess is vacuuming the carpets. There is a possibility that the power grid simply could not withstand such a load. Especially in the case when the washing machine enters the active phase, i.e. water heating or spinning laundry. For your own safety and the safety of your home, in such a case, it is advisable to seek the help of an electrician. And it is necessary if, under such a load, the network did not fail before.
- shorts out the plug or cord of the washing machine. If such damage is detected with the naked eye, such a cord must be replaced along with the plug. It is better to leave this to the master.
The most common malfunctions of the washing machine, in which the RCD (or machine) is triggered
When it knocks out traffic jams, it is obvious that something is “short”. An extremely rare but possible case may be that the washing machine knocks out the machine due to the high content of condensate on the electrical elements inside the washing machine.
In such a situation, a sufficient measure would be to leave the washing machine alone for several days in a room with good ventilation. But, keep in mind, the chance that this is exactly your case is very low.
Most often, the following unpleasant things happen to washing machines:
| Malfunction | What is the problem | Repair service cost |
| Damage to the heating element | At work washing machine heater continuously exposed to water, detergents and various particles from the laundry. All this over time leads to the “corrosion” of its shell and ensures that moisture enters the heating coil inside the unit, i.e., failure of the heating element and a short circuit.
A defective tubular electric heater needs to be replaced. |
From 11$lei |
| Control module failure
(control board) |
High humidity on the control module can cause oxidation of the contacts. Which will lead to a short circuit, and as a result, the washing machine will knock out the plugs.
A broken board must either be repaired, and if it is impossible to carry out washing machine repair - replacement. |
From 16$lei |
| Washing machine motor failure | There are two cases of interturn short circuit of the washing machine motor: the first is water leakage inside the washing machine, the second is the natural physical wear of the motor.
A damaged motor cannot be repaired, it needs to be replaced. |
From 16$lei |
| Power button failure | What is used most often in a washing machine? Of course, the power button: in fact, therefore, its contacts “age” faster than the rest. In addition to this, the possibility of oxidation, at the output we get a good opportunity to get a short circuit on the start button.
It is necessary to solder the contacts and / or replace the button. |
From 8$lei |
** The prices in the table are for repair services only, the cost of spare parts is not given in this table.
Attention! Do not, under any circumstances, use a washing machine that knocks out corks.
In the event of a short circuit, the washing machine can “break into the case”, so there is a considerable risk for you to receive an electric shock. This carries a mortal danger! And also any violation of the integrity of the electrical wiring can cause a fire! Be very careful when handling electrical appliances and the mains: take care of yourself and your home!
In the event that the washing machine causes broken plugs, immediately contact the repairmen for washing machines
Well, if the problem is in the wiring - urgently contact the electricians
