How to replace an elastic band (cuff) on a washing machine

The cuff is a necessary and important detail.

It is she who protects the electronic device of washing machines from moisture.

The function of the cuff does not end there, it prevents water from leaking out of the washing machine, thanks to the sealing of the hatch door.

Therefore, if the gum is torn, you can’t hesitate, otherwise it threatens the failure of the washing machine and more expensive repairs. It's time to learn how to replace the cuff.

When to change the cuff

There are several signs that indicate the need to replace the cuff.

1. If a puddle appears on the floor near the loading door while the washing machine is running.
2. If the sunroof does not close.
3. If a knock or hiss is heard while the washing machine is running a program.

Causes of cuff damage

The cuff in the washing machine may be physically worn out or mechanically damaged.

1. Foreign objects entering the washing machine during washing (keys, coins, pins, bra bones, etc.).
2. Washing hard items - sneakers, caps with hard visors, heavy outerwear.
3. The use of cheap detergents, which include harsh chemicals.
4. Negligent attitude to technology with the consequence of deformation of the seal, for example, neglect of the rules for loading laundry and washing programs.

What should I do if holes appear in the seal or the quality of adhesion to the drum is impaired? The simple answer is to replace. Is it possible to replace the gum in the washing machine yourself? Can.

How to replace the sealing gum in the washing machine with your own hands

Cuff replacement takes place in two stages:

1. dismantling the old cuff,
2. installation of a new cuff.

Repair will take no more than 1 hour.

Stage 1. Dismantling the old cuff

1. Pulling out the fixing clamps. The front one is attached to the body with a ring on a spring in the gum groove. You need to pry it with a screwdriver and not pull it hard. You can not be afraid of damage to the ring, because it is able to stretch. Then you need to hold on to the attachment points, remove the elastic, trying to bend its outer edge inward.
2. For further work, you will have to disassemble the front wall of the washing machine by unscrewing the screws. It is removed easily, just lift the panel and pull it towards you. At this stage, all the wires that fit the hatch lock are disconnected, if this is not possible, then the lock itself is removed.
3. The cuff of the washing tank is held similarly to the clamp on the spring ring, and is dismantled in the same way. Sometimes there are models in which the cuff is connected to the nozzle. You need to disconnect it. The cuff is removed from the tank.
4. It is necessary to carefully process the edges of the tank from contamination. You can use soapy water for this.

Stage 2. Installing a new cuff

1. For easy dressing of the cuff, it is first pulled over the neck of the tank with the larger side. After that, the inner clamp is inserted and fixed. There should not be a tight fit, otherwise fraying is possible.
2. The cuff with the smaller side is pulled over the leading edge and straightened out. Next comes the turn of the front collar.
3. The question of how to replace the gum on the washing machine has been resolved.
4. It's time to check the quality of the repair and run the rinse mode for a couple of minutes. After that, you can turn on the water drain and, by tilting the equipment to the sides, check the bottom of the rubber.

No leaks? Congratulations, the repair was successful!